Job Title

Role OverviewWe are looking for a highly skilled Mechanical Engineer with strong expertise in GAD (General Arrangement Drawings) and mechanical systems of elevators.The ideal candidate should be capable of reviewing, correcting, and coordinating mechanical drawings, verifying site measurements, and proposing technically viable alternate solutions when site deviations arise.This role demands hands-on mechanical understanding, keen technical observation, and the ability to bridge the gap between design and site execution to ensure quality installation.Key ResponsibilitiesTechnical & MechanicalStudy and verify elevator GADs and mechanical layouts before execution.Identify and correct errors, mismatches, or feasibility issues in drawings.Evaluate site clearances (shaft, pit, overhead, machine room, door openings).Propose practical alternate mechanical solutions for site deviations.Coordinate with the design team for GAD revisions and corrections.Ensure correct fitment and alignment of car frames, guide rails, machine beams, buffers, and brackets.Work with the factory and site teams to ensure fabrication and materials match corrected site conditions.Site Coordination & MeasurementTake accurate site measurements and verify them against approved drawings.Prepare and submit site measurement reports with clear documentation.Identify potential issues before installation and provide corrective guidance.Liaise with builders, architects, and contractors for technical clarifications.Support installation teams to ensure mechanical work is executed as per revised GADs.Quality & ComplianceEnsure installation meets  Elevators’ quality standards and relevant safety norms (IS/BIS).Supervise mechanical assemblies for accuracy, alignment, and workmanship.Inspect and verify materials and mechanical installations before commissioning.Coordination & ReportingCommunicate mechanical deviations and alternates effectively to office and site teams.Maintain documentation of all site-based mechanical corrections and implemented solutions.Train and guide junior technicians on reading GADs and accurate measurement practices.Required Skills & CompetenciesStrong understanding of mechanical systems in elevators.Expert in reading and correcting GAD drawings.AutoCAD proficiency (mandatory).Good knowledge of shaft geometry, load points, and structural interfaces.Excellent problem-solving and decision-making ability.Capable of taking precise measurements and ensuring mechanical fitment accuracy.Strong communication and coordination skills.Qualification & ExperienceDiploma / B.Tech in Mechanical Engineering.5 to 10 years of experience in elevator installation, site supervision, or mechanical design.Prior experience with modern controller-based elevator systems preferred.Willingness to travel for site coordination when required.CompensationCompetitive salary based on experience and technical capability.Additional site allowances and travel reimbursements as per company policy.Location: Delhi (with travel to project sites across India)Contact - 8595401369Hiringpoint.solutions@